34
Operation
2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press
Func
+
Dly
.
•
If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by mis-
take, press then enter the correct frequency.
To enter the frequency anyway, press
E
to
accept.
4. To program the next channel in sequence, press
E
then repeat Steps 2 and 3.
Searching For and Temporarily
Storing Active Frequencies
If you do not have a reference to frequencies in your
area, use a search (except weather service search)
to find a transmission.
Note: When the scanner starts searching, it auto-
matically turns on the delay function. To turn delay
on or off, press
Func
+
Dly
.
Service Search
You can search for weather, ham, marine, aircraft,
police, or fire transmissions without knowing the
specific frequencies used in your area. The scanner
is preprogrammed with all the frequencies allocated
to these services. To use this feature, press
Func
and
Svc
.
SRCH
appears and the scanner searches
starting with the weather service bank. To select a
different service bank, repeatedly press
Func
and
Svc
. Service mode appears on the display.
When the scanner stops on a transmission, press
Hold
to stop searching and listen to the
transmission.
Hold
appears. In this mode, you can
BC72 Paper OM.fm Page 34 Monday, October 25, 2004 3:11 PM
