32
1. Press
MENU
.
2. For Scan mode, select
2:SCAN OPTION
/
1:CONVENTIONAL
by rotating the
VFO
and pressing
E
.
3. Select the channel number of the stored frequency to be delayed by rotating the
VFO
and pressing
E
.
4. Select
2:DELAY
and press
E
.
5. Rotate the
VFO
to select one of the delay periods and press
E
.
6. For Search mode, select
1:SERVICE OPTION
/
:CHAIN SEARCH
/
3:DELAY
by rotating the
VFO
and pressing
E
, then set to a delay period the same way as the
Scan mode setting.
Note
: The delay periods are as follows:
• None: Delay feature off
• 1 sec.: Delays for 1 sec. before re-scanning
• 2 sec.: Delays for 2 sec. before re-scanning
• 4 sec.: Delays for 4 sec. before re-scanning
• Infinite: Stays on until
RSM
is pressed
• -2 sec.: Stays for 2 sec. only before re-scanning *
• -5 sec.: Stays for 5 sec. only before re-scanning *
• -10 sec.: Stays for 10 sec. only before re-scanning *
* Setting negative delay periods are useful if you are only interested in small seg-
ments of conversations. For example: If you set a -5 second delay, you will only
hear 5 seconds of the conversation and then the scanner will resume scanning,
whether or not the conversation is finished.
☞
Remember! You can also use
▲
or
▼
instead of rotating the
VFO
.
Also instead of pressing
E
, you can press the
VFO
control.
Channel Lockout
You can lockout any channel so it is not checked during normal
scanning. You can restore the channel to scanning when you
wish.
Lockout in Hold Mode
1. Press
▲
/
HOLD
.
2. Select a channel.
a. Enter the channel number using the keypad.
b. Press
▲
/
HOLD
again.
––– OR –––
Rotate the
VFO
up or down to change the channel.
3. Press
L/O
to lockout the channel.
L/O
appears on the display.
C 001
141.5000 NFM
UNIDEN Group A
BC785D 11/8/2 1:01 PM Page 32
