Frequency Skip
If a particular frequency continues to interrupt search scanning, it is possible to set your
scanner to skip the frequency.
To skip over a frequency, press
L/O
when stopping at the frequency you want to skip or
when in Search Hold mode.
Note
: • You can program up to 200 skip frequencies.
The 201st skip frequency entered causes the first
skipped frequency to unlock.
• If all frequencies in the search range are set to skip, a
beep sounds and it moves to Search Hold mode.
To resume searching.
1) Cancel the Frequency Skip set.
––– OR –––
2) Reset the Search Frequency range.
To cancel all skipped frequencies, press and hold
L/O
for 2 seconds in Search Hold
mode.
Storing Search Frequencies
You can quickly store any frequency you find during Search.
1. During Search, press
▲
/
HOLD
or
LIMIT
/
▼
to store or when the scanner stops on the
frequency you want to store.
2. Press
TRNFR
to store the frequency in the channel you
selected. The smallest empty channel number flashes on the
display. If necessary, you can also change the channel by
scrolling the
VFO
or using
▲
or
▼
.
3. Press
E
.
Note
: • If the frequency you want to store exists already,
WARNING
appears on the
display and you will hear a beep. (See “Duplicate Frequency Alert” on page 27.)
• After storing the frequency, it moves to the Search Hold mode.
• In case there is not a free channel, the frequency you want to store will
automatically be stored in the previous channel before you entered into Chain
Search mode.
4. Repeat steps 1, 2 and 3 after starting the search for all the Search Frequencies you want
to store.
38
SRCH 12.5k
1240.0000 NFM
Range 1
C004 0000.0000
BC785D 11/8/2 1:01 PM Page 38
