• Tone Lock (out) mode
For either a Memory channel or a Search Range, you can lock a particular subaudible
tone by pressing
L/O
after scrolling to the desired tone. The scanner will stop on any
transmission except those which may be using the locked subaudible tone.
To set your scanner, enter into the Menu mode.
1. Press
MENU
.
2. Select
3:SYSTEM OPTION
/
8:SQ MODE
by rotating the
VFO
and pressing
E
.
3. Rotate the
VFO
to select one type (
1:CSQ
,
2:TONE SQ
,
3:TONE SEARCH
)
and press
E
.
4. To set Tone Lock mode, do the following first, then select
2:TONE SQ
in step 3.
1) For Scan mode, select
2:SCAN OPTION
/
1:CONVENTIONAL
- select the
channel number - /
3:TONE DATA
/
1:CTCSS
or
2:DCS
by rotating the
VFO
and pressing
E
. With CTCSS or DCS, Tone Lock ON is set by pressing
L/O
.
2) For Search mode, select
1:SERVICE OPTION
/
:CHAIN SEARCH
/
5:TONE DATA
/
1:CTCSS
or
2:DCS
by rotating the
VFO
and pressing
E
. With
CTCSS
or
DCS
Tone Lock ON is set by pressing
L/O
.
☞
Remember! You can also use
▲
or
▼
instead of rotating the
VFO
.
Also instead of pressing
E
, you can press the
VFO
control.
Note
: • To set Tone Lock OFF for either Scan mode or Search mode, press
E
instead of
pressing
L/O
on step 1) or 2) above.
• CTCSS: Continuous Tone Coded Squelch System.
• DCS: Digital Coded Squelch.
• For example, the scanner shows the following displays. When Search mode and
Tone Search are selected, the display shows the frequency and tone data
alternately.
• If the delay feature (-2 sec/-5 sec/-10 sec) has been set while in Tone search
mode, it resumes scanning according to the delay setting.
40
BC785D 11/8/2 1:01 PM Page 40
