8.
Press
S
to start
AutoStore
.
You can press
P
to change the step
increment during
AutoStore
.
Press
P
until you select the increment you
want. If you select the default step
increment for the frequency band you’re
searching, the indicator stops flashing.
AutoStore
stops automatically when all
available channels in the selected bank(s)
have been programmed.
9.
Press
m
to exit AutoStore and return
to the manual mode.
Note:
If you want to exit AutoStore before all the available channels are programmed, you must
press
m
twice.
Transferring a Programmed Frequency
Except for frequencies stored in priority channels, you can send any frequency to another channel
by following these steps.
You cannot transfer a frequency which is
stored in a priority channel. Error will flash
for two seconds and then your scanner
resets. If you want to transfer the
frequency stored in a priority channel, you
must designate another channel in the
bank as the priority channel. For more
information about Changing a Priority
Channel, see page 26.
1.
Select the channel with a frequency you
want to assign to a different channel.
P
18
