2.
Press
h
to move to the next higher
frequency
— or —
3.
Press
i
to move down to the
previous frequency.
Note:
You can also use the Rotary Tuner to move to other frequencies, just make sure that FREQ
is selected before turning the dial.
4.
Press
S
to resume searching.
Data Skip
A scanner will normally stop on any transmission it receives. This means the
BC895XLT
will stop
on data signals and unmodulated transmissions. You can automatically skip many of these types of
transmissions during searches.
1.
Press
d
to activate the data skip
feature.
The
d
indicator appears on the
display.
2.
Press
d
again to cancel the data skip
feature.
The
d
indicator disappears
from the display.
When data skip is active, your scanner may pause momentarily on an unwanted signal but will
resume searching in 2 or 3 seconds.
Channel Skip
If a particular channel continues to interrupt search scanning, it is possible to set your scanner to
skip the frequency.
To skip a frequency, press
L
.
Note: You can program up to 20 skip
frequencies. The 21st skip frequency
entered causes the first skipped
frequency to unlock.
SCAN
MANUAL
PRI TRUNK DATA
L/O
DELAY
CTCSS
1
2
4
7
5
8
0
3
6
9
E
31
