If you enter a non-800 MHz trunked
repeater output frequency, an error
message displays for two seconds and
then the scanner resets.
4.
Press either
m
or
h
to select the
next channel in the bank.
5.
Repeat steps 3 and 4 until all frequencies
have been entered.
6.
Press
S
to begin searching the bank
you’ve programmed.
Note: You will see the frequencies
quickly displaying as your scanner looks
for the data channel which controls the
system.
Searching a Trunked Bank
Before you Search a Trunked Bank with your scanner, consider the following:
You can only trunk track one bank at a time.
Use
t
to toggle between the conventional and the trunk tracking modes.
Press
d
while in the Trunk Tracking mode to review which bank is currently in use. The
appropriate bank icon will flash at the top of the display for 5 seconds.
If you have programmed frequencies for a trunked system in one or more of the 10 available banks
and you are in conventional mode, follow these steps to begin trunk searching:
1.
Press
t
.
The bank indicators begin to flash.
2.
Use the alpha keys to select the trunked
bank you want.
For example press
B
.
Note: You will see the frequencies
quickly displaying as your scanner looks
for the data channel which controls the
system.
40
