Restoring Default Tracking
Your scanner is set to monitor Type II systems as its default. However, if you select a preset fleet
map or program your own fleet map, then you’ll change the default setting. To reset the Type II
default for a trunking bank, follow these steps:
1.
Select the Trunking Programming mode
and the bank you want to change.
2.
Press
d
.
3.
Use
h
or
i
to choose
E2
.
4.
Press
e
.
The scanner exits the Trunking
Programming mode, acquires the data
channel, and begins searching.
Note:
Your scanner saves the setting for the preset map you selected or the Type I fleet map you
programmed. If you decide to select E1 for the bank again, the last settings used will
display.
Programming a Hybrid System
A Hybrid system is simply a Type I system with some blocks designated as Type II blocks. To
program a Hybrid system, follow the steps listed in Programming a Fleet Map in the previous
section. However, if you want a block to be Type II, select Size Code S-0.
When you begin searching a trunking bank with a Hybrid Fleet Map, you will see both types of
system IDs. That is, Type II IDs usually appear as an even number without a dash; Type I IDs
appear as a three or four digit number, followed by a hyphen, followed by a one or two digit number.
See page 58 for more information.
51
