Friday, November 07, 2008
141
[1-3 / sr1-3] key
Press this key to start searching the search range set at
Set Search Key
.
[4 / LEFT / ifx] key
Press this key to exchange the IF(intermediate frequency) for receiving radio signals to avoid interference.
[5 / lvl ] key
Press this key to change the volume offset level.
[6 / RIGHT / disp] key
Press this key to change the Display Mode.
(Display mode 1 -> Display mode 2 -> Display mode 3 -> Display mode 1 ->
͙
.)
[7 / att] key
Press this key to toggle the attenuator setting.
Long press this key to toggle the global attenuator setting.
[8 / rev] key
Long press this key to show the reverse frequency for the current frequency.
And release this key to return to the current frequency.
[9 / mod] key
Press this key to toggle the modulation state for global setting.
[0 / wx] key
Press this key to change WX Alert Priority Mode.
Long press this key to start WX Scan.
[. / no / pri] key
Press this key to toggle Priority Mode for conventional priority.
[E / yes / gps] key
Press this key to change to the GPS Mode.
[MENU] key
Press this key to go to the editing menu for the current system or current search range.
If the current system is a protected system, the scanner displays
͞
Protected System
Access Not Allowed
Press Any Key
͟
and sound an error tone.