Friday, November 07, 2008
47
If you enter less than
͞
125Hz
͟
, the scanner prompts
͞
Out of Range" and "Set Min? (Y/N)
͘͟
Press [E / yes /
gps] to set the minimum spacing frequency (125Hz). Or, press [. / no / pri] to return to editing state.
If you enter over
͞
128.0kHz
͟
, the scanner prompts "Out of Range" and "Set Max? (Y/N)". Press [E / yes /
gps] to set the maximum spacing frequency (128.0kHz). Or, press [. / no / pri] to return to editing state.
Note: The scanner displays
͞
n:---------/----
͞
(n : Band Plan number) in Select Plan when the base frequency
is
͞
0MHz
͟
. It means the number is not used.
Edit Band Plan (Mot)
This menu is shown when the selected system is a MOT type system.
You can select one of three kinds of band plans:
800/900 Standard
800 Splinter
Custom
To properly track Motorola VHF and UHF systems and rebanded 800 MHz systems, you should select
͞
Custom
͟
and enter what is known as the base frequencies (Lower and Upper), the spacing frequencies
and channel offsets for each System.
To select the custom Band Plan number, turn the [Scroll Control] to select its number from 1 to 6.
Band Plan 1
Band Plan 2
Band Plan 3
Band Plan 4
Band Plan 5
Band Plan 6
Then press[E / yes / gps] is pressed. You are then prompted to set the detailed information of band plan.
Set Base Freq
Set Offset
Set Spacing
When you select
͞
Set Base Freq
͟
, you are then prompted to
͞
Input Lower
͟
then
͞
Input Upper
͟
. Use the
number keys and decimal key to input frequencies. Press [E / yes / gps] to set the frequency. If the entered
frequency is out of band,
͞
Out of Band
͟
will be shown with an error tone. Press any key to go back to
editing the base frequency.
When you select
͞
Set Offset
͟
, you can set the channel offset for the band plan entry. You can set the
Offset from -1023 to +1023. Enter the absolute value using the number keys. If you input a value over
1023,
͞
Out of Range
͟
and
͞
Set Max? (Y/N)
͟
will be shown. Press [. / no / pri] to return to editing state.
Press [E / yes / gps] to set the value to maximum number (1023) and you will be prompted to
͞
Select
Polarity
͟
. Select
͞
+ Polarity
͟
or
͞
- Polarity
͟
, then press [E / yes / gps] to confirm the setting.
