110
Call mode and stores any Close Call hits, up to the maximum you specified in the
Max Auto Store
setting. If the scanner stores more hits than this setting, it stops
auto store operation.
Turn the
Scroll Control
to display an option, then press
F
.
Set CC Mode
— Lets you select the Close Call mode. If you set
CC DND
or
CC
Pri
, then every 2 seconds the scanner switches the filter settings to the ones set
by the CC Bands option.
Off
— Close Call is turned off for all modes.
CC DND
(Do Not Disturb) — The scanner checks for a Close Call hit every 2
seconds only if the scanner is not currently stopped on a transmission. If the
scanner is on a transmission the scanner waits until the signal ends to perform a
Close Call check. This prevents breaks in audio during Close Call checks.
CC Pri
(Primary) — Close Call operates if a carrier is detected.
Set CC Override
— Lets you select how the Close Call feature works with other
scanning activities. If you turn this option off, when the scanner detects a Close
Call signal,
CC Found! Press Func Key
appear for the time you set in
Set
CC Pause
. Press
F
when this appears to jump to and hold on the frequency.
If this option is turned on, the scanner overrides the current channel and goes to
the Close Call hit. The scanner displays
CC Found! Press Any Key
.
When
you press a key, the frequency appears.
Set CC Alert
— Lets you select how the scanner alerts you when it receives a
Close Call signal. You can select from these options.
Select Beep
— The scanner beeps when it receives a Close Call signal. You
can set the beep alert in the following manner.
Off
(the scanner does not beep)
Alert 1-9
— The scanner sounds a specialized beep to notify you of a Close
Call hit. When you select an alert type, the scanner automatically enters the setting
of the Alert volume level. Each alert has a unique one or sound pattern.
Set CC Pause
— Lets you select how long the scanner waits after a hit before it
returns to the previous operation. Your options are:
3/5/10/15/30/45/60 sec.
Infinite
— The scanner stops and requires you to manually select another
operation to enable its return.
