91
Programming Your Scanner
[MENU]
Program System
F
Select a trunked system
F
Edit Site
(current)
F
Select a site
F
Set C-Ch Only
F
This setting determines the frequencies you need to enter for Motorola systems.
Select your setting, then press
F
.
On
— You only need to enter control channel frequencies.
Off
— You must enter all voice and control channel frequencies.
Note:
The scanner defaults to
On
.
[MENU]
Program System
F
Select a trunked system
F
Edit Site
(current)
F
Select a site
F
Set LocationInfo
F
This setting control whether the system is automatically enabled and disabled
when you connect a GPS to the scanner.
Set
Latitude
— Enter the system’s latitude using the format you selected in the
system settings.
Set
Longitude
— Enter the system’s longitude using the format you selected in
the system settings.
Set Range
— Set the system’s range using the units you selected in the system
settings.
Set GPS Enable
— Depending on the data received from the GPS, the L/O
status of the site is automatically controlled
.
Assigning a Trunked System to A State
In addition to the BearTracker System Preprogrammed State information, you may
want to program another system in that same state. Then, when you turn on that
state using the
[STATE]
control and the
Scroll Control
, the system you program
will also be unlocked and scanned.
Setting Control-Channel Only Mode
M
Setting Site Location Information
MESL
