10
As an alternative, the power cord may be connected to an available
terminal on the fuse block or to a point in the wiring harness. However,
caution must be taken to prevent a short circuit. If in doubt, contact your
vehicle dealer for information.
Ground Information
This transceiver may be installed and used in any 12-volt DC negative ground
system vehicle.
Negative Ground System
With a negative ground system, the negative (-) battery terminal is
usually connected to the vehicle motor block.
Connect the red DC power cord from the
transceiver to the positive (+) battery terminal
or other convenient point. Then connect the
black power cord to the vehicle chassis or negative (-) battery terminal.
INSTALL 6-PIN TO 4-PIN ADAPTER
The Bearcat 880FM is pre-configured for Uniden’s 6-pin wireless, noise-
cancelling technology. Your Bearcat 880FM comes with an adapter
to connect the radio’s 6-pin microphone to a current standard 4-pin
microphone.
1. Insert the 6-pin side of the adapter into the Bearcat 880FM 6-pin
microphone connection.
2. Plug a standard 4-pin microphone connector into the 4-pin side
of the adapter.
MARINE INSTALLATION
Consult your dealer for information regarding marine installation. It is
important to adequately ground the system and to prevent electrolysis
between the fittings in the hull and the water.
Summary of Contents for Bearcat 880FM
Page 2: ......
