Easier to Read BCD396T/UBCD396T Digital Scanner Manual
Scroll to
Set Step
and press
E/yes
. See also
Scroll to
Auto
,
5
,
6.25
,
7.5
,
8.33
,
10
,
12.5
,
15
,
20
,
25
,
50
, or
100
to set the step size and press
E/yes
.
Scroll to
Set C-Ch only
and press
E/yes
. (for Motorola and LTR systems).
Scroll to
On
or
Off
and press
E/yes
.
Scroll to
Adjust p25 Level
and press
E/yes
.
Scroll to one of three settings and press
E/yes
.
Auto
- the scanner automatically adjusts the digital decode threshold to match the transmission you are hearing when it receives a strong signal and has a
high decode rate.
Manual
- lets you manually adjust the digital decode threshold.
Default
- sets the digital decode threshold to the default value. This is handy if you have manually adjusted the value to a setting that prevents proper
decoding.
Scroll to
Search with Scan
and press
E/yes
.
Scroll to
Set Lockout
and press
E/yes
. (For use for with 'Search with Scan').
Scroll to '
Unlocked
', '
Temporary L/O
', or '
Lockout
' and press
E/yes
to save and exit.
Scroll to
Set Hold Time
and press
E/yes
.
Enter the hold time (
0-255
seconds) you desire and press
E/yes
to save and exit. (
0
will search the
whole
band before continuing).
Press
Menu
to exit.
Press
Menu
and scroll to another custom search and repeat the previous steps or press
L/O
to exit.
Custom Search
lets you search the scanner's 10 programmed frequency ranges. See
To start a Custom Search
, in scan mode
Press and hold
Func
then press
Scan/Srch
.
At '
Quick Search?
' press
(.)no
.
At '
Search for...
' scroll to '
Custom Search
' and press
E/yes
Searching
(only, not search w/scan)
To start a search see
To toggle search bands on or off (custom search)
, press the number key of the search band.
To hold on a frequency
, press
Hold
. Press
Hold
to resume.
To step through the frequencies
, turn the scroll. Press
Hold
to resume.
To change search direction
or continue searching
, turn the scroll control back or forward.
To step through the frequencies
, press
Hold
. Turn the scroll control back or forward while in hold mode. Press
Hold
to resume.
To lock out a frequency
, press
L/O
.
To unlock frequencies
Reviewing Locked Out Frequencies
.
To check for a repeater frequency
, press
Hold
to hold on the frequency then
press and hold
.no(rev)
. Press
Hold
to resume.
To attenuate a search
,
press and hold
Func
then press
E/yes(att)
.
To save a frequency
, press
Hold
to hold on the frequency then see
Programming Displayed Frequency
.
To turn Close Call on or off
,
press and hold
Func
then
Hold
,
Programming a Displayed Frequency (while searching)
http://marksscanners.com/396/396.shtml (35 of 51)8/17/2010 10:11:40 PM
