34
If an AC adapter is connected to the scanner, the
scanner checks the condition of the installed batteries.
If the scanner is turned off and the batteries require a
full charge,
Normal Charging
appears as the bat-
teries are recharged. When the batteries are fully
charged,
Charge Complete
appears.
If no batteries are installed in the scanner,
No Battery
appears. If there is a problem with the installed batteries,
Battery Error
appears. If the installed batteries are
Ni-MH batteries but
ALKALINE/Ni-MH
is set to
ALKALINE
,
Charge Off
appears and the scanner
does not charge the batteries.
Removing the Display Sticker
Before you use the scanner, remove the protective
plastic sticker over the display.
Using AC Power
You can power the scanner
using the supplied 6V,
800 mA AC adapter.
To use the scanner on AC
power, plug the adapter into
6V 800 mA
on the right side
of the scanner, then plug the
AC adapter into a standard AC
outlet.
If rechargeable batteries are installed and
ALKALINE/
Ni-MH
is set to
NI-MH
, the adapter powers the scanner
and recharges the installed batteries at the same time.
WARNING!
To prevent damage to Ni-MH batteries, never charge
them in an area where the temperature is above
113°F (45°C) or below 32°F (0°C).
Summary of Contents for BR330T
Page 1: ...BR330T OWNER S MANUAL OWNER S MANUAL ...
Page 153: ...153 One Year Limited Warranty ...
Page 154: ...154 ...
Page 155: ...155 One Year Limited Warranty ...