3
Installing the Belt Clip
Lne up the tabs wth the holes on each sde of
the handset. Press the belt clp down untl both
tabs clck nto place.
To remove the belt clp, pull both sdes of the clp
to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used wth an optonal
headset. To use a headset, nsert the headset
plug nto the headset jack. Headsets may
be purchased by callng the Unden Parts
Department. See nsde the back cover page for
contact nformaton.
Charging the Accessory Handset
The handset s powered by a rechargeable battery pack that
automatcally recharges when the handset s placed n the
charger.
Connect the AC adapter to the
DC IN 9V
jack and to a 20V
AC outlet that s not controlled by a wall swtch.
Caution: Use only the Uniden AD-0005 adapter.
Set the charger on a
desk or tabletop, and
place the handset n the
charger wth the keypad
facng forward.
Make sure that the
charge
LED llumnates.
If the LED does not
llumnate, check to see
that the AC adapter
s plugged n and
the handset makes
good contact wth the
chargng contacts on the charger.
Charge the handset battery pack for at least 5-20 hours
before using your new handset for the first time.
)
2)
3)
4)
To AC outlet
To DC IN 9V
AC adapter (supplied)
Route the cord.
Caution: Use only the Uniden AD-0005 adapter.
To AC outlet
To DC IN 9V
AC adapter (supplied)
Route the cord.
Caution: Use only the Uniden AD-0005 adapter.
DCX200.indd 3
2007/07/04 13:51:44
