17
You must subscribe to Caller
ID and Call Waiting through
your telephone company.
REGISTERING A HANDSET TO A BASE UNIT
Each handset must be registered to a base unit in order to make and receive calls.
The DECT 1811 is automatically registered to the first base unit for you.
A handset can be registered to up to four base units.
• press and hold the
[PAGE]
key on your base until ringing begins (5-10 seconds).
You will then be ready to register another handset to your base unit.
• press
[menu]
key until you reach the
H-REGISTER
display on the LCD.
• press
[OK]
key to choose this menu item.
•
SEARCH BS 1
will be displayed.
• press
[menu]
key to scroll between base units
2-4 (any available base number is OK).
• press
[OK]
to confirm your choice.
• the RFPI code will be displayed after a short wait.
• press
[OK]
to confirm.
• enter your base unit PIN number and press
[OK]
.( Factory default is 1590).
SELECTING A BASE UNIT
If your handset is registered to several base units, the selection of the most
appropriate base unit can be done manually or automatically.
• press
[menu]
key until you reach the
SELECT BASE
display on the LCD.
• press
[OK]
key to choose this menu item.
•
BASE NO: 1
will be displayed.
• press
[menu]
key to scroll between base units
1-4
or
AUTO
.
• press
[OK]
to confirm your choice.
• press
[OK]
to register to this new base unit.
INSERT ZERO CALLER ID
(Default: New Zealand On, Australia Off)
If you are subscribed to a telephone network that does not require a zero inserted
for Caller ID switch off as follows:
• press
[menu]
key until you reach the
EAR VOLUME
display on the LCD.
• press
[OK]
key to choose this menu item.
• press
[menu]
until you reach
VOL MIDDLE
.
• press
#
then number
4
key.
• press talk
[
]
.
H-REGISTER
If your handset has not been
subscribed to your chosen
base unit,
NOT SUB:
will
be displayed. In this case, try
again by choosing another
base or subscribe the
handset to the new base first.
