background image

 

x

Reorient or relocate the receiving antenna.

 

x

Increase the separation between the equipment and receiver. 

 

x

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

 

x

Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Information

This product complies with FCC radiation exposure limits under the following conditions: 

 

x

The base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all 

persons during normal operation. 

 

x

The base must not be collocated or operated in conjunction with any other antenna or transmitter. 

 

x

The handset is designed for body-worn operation and meets FCC RF exposure guidelines when 

used with any belt clip, carrying case, or other accessory supplied with this product. (All necessary 

accessories are included in the package; any additional or optional accessories are not required for 

compliance with the guidelines.) Third party accessories (unless approved by the manufacturer) 

should be avoided as these might not comply with FCC RF exposure guidelines. 

Industry Canada (I.C.) Notice

Terminal equipment

NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical 

Specifications. This is confirmed by the registration number. The abbreviation 

IC

 before the 

registration number signifies that registration was performed based on a Declaration of 

Conformity indicating that Industry Canada technical specifications were met. It does not imply 

that Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the 

equipment itself. The REN assigned to each terminal equipment provides an indication of the 

maximum number of terminals allowed to be connected to a telephone interface. The termina-

tion on an interface may consist of any combination of devices subject only to the requirement 

that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

Radio equipment

The term 

IC

 before the radio certification number only signifies that Industry Canada technical 

specifications were met. Operation is subject to the following two conditions: (1) this device 

may not cause interference, and (2) this device must accept any interference, including interfer-

ence that may cause undesired operation of the device. "Privacy of communications may not be 

ensured when using this telephone."

One-Year Limited Warranty

Evidence of original purchase is required for warranty service. 

WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") 
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this 

Uniden Product to be free from defects in materials and craftsmanship with only the limitations 

or exclusions set out below. 
WARRANTY DURATION: This warranty to the original user shall terminate and be of no further 

effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) 

damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of 

any conversion kits, subassemblies, or any configurations not sold by Uniden, (C) improperly in-

stalled, (D) serviced or repaired by someone other than an authorized Uniden service center for 

a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or 

parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by 

anyone other than as detailed by the owner's manual for this product. 
STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at 

any time while this warranty is in effect, warrantor will either, at its option, repair or replace the 

defective unit and return it to you without charge for parts, service, or any other cost (except 

shipping and handling) incurred by warrantor or its representatives in connection with the per-

formance of this warranty. Warrantor, at its option, may replace the unit with a new or refur-

bished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY 

PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES 

OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF 

LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR 

FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR 

THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some 

states do not allow this exclusion or limitation of incidental or consequential damages so the 

above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other 

rights which vary from state to state. This warranty is void outside the United States of America 

and Canada. 
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions 

in the owner's manual you are certain that the Product is defective, pack the Product carefully 

(preferably in its original packaging). Disconnect the battery from the Product and separately 

secure the battery in its own separate packaging within the shipping carton. The Product should 

include all parts and accessories originally packaged with the Product. Include evidence of 

original purchase and a note describing the defect that has caused you to return it. The Product 

should be shipped freight prepaid, by traceable means, to warrantor at:
Uniden America Service 

4700 Amon Carter Blvd. 

Fort Worth, TX 76155
As an Energy Star® Partner, Uniden has determined that this product meets 

the Energy Star® guidelines for energy efficiency. Energy Star® is a  

U.S. registered mark.

 

x

Uniden® is a registered trademark of Uniden America Corporation.

 

x

The pictures in this manual are for example only. Your phone may not look exactly like the pictures.

May be covered under one or more of the following U.S. patents: 

5,491,745  5,533,010  5,574,727  5,581,598  5,606,598  5,650,790  5,660,269  5,663,981 

5,671,248  5,717,312  5,732,355  5,754,407  5,758,289  5,768,345  5,787,356  5,794,152 

5,801,466  5,825,161  5,864,619  5,893,034  5,912,968  5,915,227  5,929,598  5,930,720 

5,960,358  5,987,330  6,044,281  6,070,082  6,076,052  6,125,277  6,253,088  6,321,068 

6,418,209  6,618,015  6,714,630  6,782,098  6,788,920  6,788,953  6,839,550  6,889,184 

6,901,271  6,907,094  6,914,940  6,953,118  7,023,176  7,030,819  7,146,160  7,203,307 

7,206,403  7,310,398  7,460,663 

Other patents pending.

© 2010 Uniden America Corp. 

Printed in Vietnam 

Ft. Worth, Texas 

UNZZ01181ZZ(0)

Summary of Contents for DECT1340







Reviews: