Issue 1, November 2014
Press and hold MUTE/DIM. The detector announces the brightnes level as it
changes to that level. Press and hold the keys again to move to the next level.
TURN BANDS ON/OFF
The
DFR7
monitors X (HIGHWAY only), K, and Ka bands as well as Laser
transmissions.
CHANGE HIGHWAY TO CITY AND BACK
Press and hold both VOL +
and
VOL –
for at least 2 seconds to alternate between
HIGHWAY and CITY setting.
MARK USER POINTS (RADAR/LASER SITE)
With the
DFR7
, you can mark geographical points where you commonly
encounter radar transmissions, These can be school zones, red-light cameras,
and places where police frequently monitor traffic. You can mark these points
so the detector will announce and sound an alert when you approach them.
When you are at the location, press MARK. The detector announces “User mark
logged” and sounds an alert tone. Now, when you approach these points, the
detector announces “Attention” and begins a distance countdown to the point
of marking.
Press and hold MARK at that location to delete that user point.
TROUBLESHOOTING
IF...
TRY THIS...
No display or audio.
Check the fuse in the plug. Replace if
necessary.
The unit alarms when the vehicle hits
bumps.
Check the connections. Be sure they
are all secure.
The unit alarms briefly in the same
location but no radar source was in view.
There may be a motion sensor or
house alarm in use within range.
The detector did not alert when a police
car was in view.
• The officer may not have radar/
laser units turned on.
• Check that the band are turned
on. Press
MENU
. If the band is
turned on, the LCD will show ON.
The car starts but the detector does not
turn on.
• Verify that the power cord is
securely connected to the unit
and inserted into the cigarette
lighter jack.
• Change the fuse in the power
cord. Unscrew the cigarette
lighter jack to access the fuse.
SPECIFICATIONS
Receiver Type:
Antenna Type:
Radar
Double Conversion
Superheterodyne
Self-Contained Antenna
Radar
Linear Polarized
E-vector Vertical
Laser
Pulsed Laser Signal
Receiver
Laser
Front
Convex Condenser
Lens
Frequency:
Laser
Back
Concave
Condenser Lens
X
10.525 GHz
Dimensions
110.00 mm (D) x
69.00 mm (W) x
29.50 mm (H)
K
24.150 GHz
Weight
4.1 oz (115g)
Ka
33.400 - 36.000 GHz
Operating
Temp.
-4° to +185° F
(Radar/Laser)
-20° to +85° C
(Radar/Laser)
Laser
800 nm - 1100 nm
Storage Temp.
-22° to +203° F
(Radar/Laser)
-30° to +95° C
(Radar/Laser)
Detector Type:
Operating
Power Soure
DC 11.0 to 16.0 V
Radar
Scanning Frequency
Discriminator
Laser
Pulse Width
Discriminator
Alarm Type
Beep (Detected Band
and Signal strength)
Storage Temp
(Radar/Laser).
-22° to +203° F
-30° to +95° C
Operating
Power Soure
DC 11.0 to 16.0 V
FCC/Industry Canada Information
FCC: AMW
UA1602
ICC: 513C-
UA1602
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Unauthorized changes or modifications to this equipment may void compliance
with the FCC Rules. Any change or modification must be approved in writing
by Uniden. Changes or modifications not approved by Uniden could void the
user’s authority to operate the equipment.
L’appareil est conforme aux normes d’Industrie Canada. Son fonctionnement
est soumis aux deux conditions suivantes : (1) Ce dispositif ne doit pas causer
d’interférences et (2), il doit pouvoir accepter les interférences, incluant celles
pouvant nuire à son fonctionnement normal.
Tous les changements apportés à cet appareil, s’ils ne sont pas expressément
approuvés par Uniden ou toute utilisation de celui-ci d’une autre manière
que celle décrite dans ce guide peut annuler votre autorisation de le faire
fonctionner.
Limited Warranty
Keep your receipt! Proof of purchase is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORP. (“Uniden”)
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail
owner, this Uniden Product to be free from defects in materials and craftsman-
ship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate and
be of no further effect 12 months after the date of original retail sale. The
warranty is invalid if the Product is (A) damaged or not maintained as reason-
able or necessary, (B) modified, altered, or used as part of any conversion
kits, subassemblies, or any configurations not sold by Uniden, (C) improperly
installed, (D) serviced or repaired by someone other than an authorized
Uniden service center for a defect or malfunction covered by this warranty, (E)
used in any conjunction with equipment or parts or as part of any system not
manufactured by Uniden, or (F) installed or programmed by anyone other than
as detailed by the Operating Guide for this product.
STATEMENT OF REMEDY: In the event that the product does not conform to
this warranty at any time while this war-ranty is in effect, warrantor will repair
the defect and return it to you without charge for parts, service, or any other
cost (except shipping and handling) incurred by warrantor or its representa-
tives in connection with the performance of this warranty. THE LIMITED WAR-
RANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING
TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES
OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY
OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WAR-
RANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS
WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR
PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not
allow this exclusion or limitation of incidental or consequential damages so the
above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state. This warranty is void
outside the United States of America.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following
the instructions in this Operating Guide, you are certain that the Product is de-
fective, pack the Product carefully (preferably in its original packaging). Include
evidence of original purchase and a note describing the defect that has caused
you to return it. The Product should be shipped freight prepaid, by traceable
means, or delivered, to warrantor at:
Uniden America Corporation
C/O Saddle Creek
743 Henrietta Creek Rd., Suite 100
Roanoke, TX 76262
(800) 297-1023, 8 a.m. to 4:30 p.m., Central, Monday through Friday
POP Mode is a trademark of MPH Industries, Inc.
