[ 1 3 ] G E T T I N G S T A R T E D
w w w . u n i d e n . c o m
6) Press the
end
key to complete the setting. The handset returns to standby mode.
Choosing the Dialing Mode
Most phone systems use tone dialing. However some phone systems (such as in rural areas)
still use pulse dialing. Your Uniden phone supports both tone and pulse dialing. The default
setting is tone dialing. If your phone system uses pulse dialing, follow the steps below to
change the dialing mode:
1) When the phone is in standby mode, press and hold the
caller id/
menu
key. The following screen appears.
2) Press the
/
vol/
key three times to select
D ial
.
3) Press the
select/remote
key to set the phone to pulse dialing.
4) Press the
end
key to complete the setting. The handset returns to
standby mode.
Setting the Language
There are three languages to choose from; English, French and Spanish.
1) When the phone is in standby mode, press and hold the
caller id/
menu
key. The following screen appears.
2) Press the
/
vol/
key four times to select
Lan gua ge
.
•If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave
the setting as is.
Otherwise, set for
pulse dialing.
•If your phone system
requires pulse dialing
and you need to send
DTMF tones during a
call, you can
temporarily switch
over to tone dialing.
(Refer to “Tone Dialing
Switch-over” on
page 17.)
note
G
ETT
ING
S
T
A
R
T
E
D
EXAI7248.book 13 ページ ２００４年１月１５日 木曜日 午前１１時５６分
