GETTING STARTED
G E T T I N G S T A R T E D
[ 15 ]
1) When the phone is in standby mode, press and hold
cid/menu
. The Caller ID setting screen appears.
2) Press
3
or press
twice to select ¨
Area Code
¨.
3) Press
select
.
4) Use the number keys (
0
to
9
),
#/
,
*
/tone/
or
delete/ch
to enter the 3-digit area code.
5) Press
select
. A confirmation tone sounds and the displayed area code is entered.
6) Press
end
or return the handset to the base unit. The handset returns to standby
mode.
When the area code has already been stored in memory, the
stored area code will be displayed. To change it, use the
delete/ch
and number keys to enter the new area code. Then
press
select
. A confirmation tone sounds.
To complete the setting, press
end
or return the handset to the
base unit.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However, some phone systems (such as those in rural areas) still use pulse
dialing. The default setting is tone dialing. If neccesary, follow the steps below to
change the dialing mode to match your phone company’s dialing system:
Make sure your battery
pack is fully charged
before choosing the
dial mode.
EXI386M 8/11/03 5:38 PM Page 15
