Uniden Grant LT, User Manual

9

RF Meter

:  Measures RF Output Power for transmitter. To use the RF Meter, position

the Meter Selector at 

S/RF

.  Press the microphone 

PTT

Switch to read your

transmitting RF power.

S-Meter

:  Measures incoming signal strength. To use the S-meter, position the Meter

Selector at 

S/RF

. The meter swings to indicate signal strength.

i.e. 

S 3, S 5, S 7 . . .

Every six months:

1. Check the Standing Wave Ratio (

SWR

).

2. Be sure all electrical connections are tight.

3. Inspect antenna coaxial cable for wear or breaks in shielding.

4. Be sure all screws and mounting hardware are tight.

The 

Grant LT

is designed to give you years of trouble-free service.  There are no

user-serviceable parts inside. Except for the fuse in the DC power cord, no
maintenance is required.

To replace a blown fuse:

1. Press ends of the fuse holder       

together. Twist to open.
Carefully separate the 
two pieces.

2. Remove the fuse and inspect. 

If blown, replace with the same
type fuse.

M

Ma

aiin

ntteen

na

an

nccee

P

Prreev

veen

nttiiv

vee  M

Ma

aiin

ntteen

na

an

nccee

Use only the fuse specified for your 

Grant LT

(4-ampere 3 AG fuse)

. Failure to do so may

void your warranty. 

Grant LT.qxd  3/31/99  10:03 AM  Page 9