Uniden Grant LT, User Manual

13

General

Channels:

40

CB Frequency Range:

26.965 to 27.405 MHz

Frequency Control:

Phase Locked Loop (PLL) synthesizer

Frequency Tolerance:

±0.005%

Frequency Stability

0.001%

Operating Temperature:

-30°C to +50°C

Microphone:

Plug-in dynamic with PPT (push to talk) switch an d coiled cord

Input Voltage:

13.8 VDC nominal, 15.9V max, 11.7V min
(positive or negative ground)

Current Drain:

TX: AM full modulation, 2.2 A 
SSB 120 watts, PEP output, 2A
RX: Squelched, 0.25 A; with maximum audio output, 0.6A

Size:

7-7/8” (W) x 9-3/8” (D) x 2-3/8” (H)

Weight:

4 lbs. 10 oz. with microphone

Antenna Connector:

UHF, SQ-239

Meter 

(3-in-1)

Illuminated; indicates relative power output and received 
signal strength, and SWR.

Transmitter

Power Output:

AM, 4 watts
SSB, 12 watts, PEP

Modulation:

High - and low-level, Class B amplitude modulation

Intermodulation Distortion:

SSB:  3rd order, more than -25dB, 5th order, more than 35dB

SSB Carrier Suppression:

55dB

Unwanted Sideband:

50dB

Frequency Response:

AM and SSB; 300 to 3000 Hz

Output Impedance:

50 ohm, unbalanced

Output Indicators:

Meter shows realtive RF output power and SWR Transmit LED 
glows red when transmitting

Receiver

Sensitivity:

SSb:0.25 µV for 10 dB, (S+N)/N at greater than 1/2 watt of audio output
AM: 0.5 µV for 10 dB; (S+N)/N at greater than 1/2 watt of audio output

Selectivity:

AM: 6 dB @ 3 kHz, 50 dB; @ 9 kHz
SSB: 6dB @ 1.1kHz, 60dB @ 2.3kHz

Image Rejection:

More than 65 dB

Adjacent-Ch. Rejection:

60 dB AM; 70 dB SSB

IF Frequencies:

AM: 7.8 MHz 1st IF, 455 kHz 2nd IF
SSB: 7.8 MHz

Automatic Gain Control (AGC):

Less than 10 dB change in audio output for inputs from 10 to 100,000 µV 

Squelch:

Adjustable; threshold less than 1 µV

AM and SSB RF Gain Control:

40 db adjustable for AM and SSB

Clarifier Range:

1.5 kHz

Audio Output Power:

4 watts into 8 ohms

Frequency Response:

300 to2500 Hz

Internal Speaker:

8 ohms, round

External Speaker:  

(not supplied)

8 ohms, disables internal speaker when connected

PA System

Power Output:

4 watts into external speaker

External Speaker for PA
speaker: 

(not supplied)

8 ohms 

Specifications shown are typical and subject to change without notification.

S

Sp

peecciiffiicca

attiio

on

nss

Grant LT.qxd  3/31/99  10:03 AM  Page 13