8
UNLOCK
position then lift the plastic flap on the
base to release it from the windshield.
INSTALLING THE MICROSD CARD
A compatible microSD card (8GB supplied) is
required to record and store videos and photos.
The camera can support microSDHC cards (High
Capacity microSD) up to 32GB in capacity. Uniden
recommends using a good quality microSDHC card of at
least 8GB capacity and minimum Class 10 speed.
Gently insert a formatted microSD card in the slot on the
side of the camera. To remove the card from the slot,
press the edge of the microSD card inwards for it to pop
out and then pull it out of the slot.
POWERING UP THE DC2
Only use the DC car adapter that comes with your
device. Any other adapter might damage the device.
1. Refer to your car’s owner’s manual to verify where
the power outlets are on and around the dashboard.
Locate an outlet that supplies 12V electric power
when the key is in the ON or ACC position.
2. Connect the car adapter to the camera and to the
that power outlet.
3. Start the car. The camera turns on automatically
and begins recording. When the car’s engine is
turned off, the camera will automatically turn off in a
few seconds.
Charge the camera for at least 15 minutes after it is
turned on for the first time or after it has been turned
