E-17
Uniden MHS126 Radio Owner’s Manual
Setting Up the Hardware
Attaching the Antenna
The antenna detaches from the radio for
easy shipping or storage. To attach the
antenna to your radio, screw it tightly onto
the anchor post at the top of the radio.
Installing the Battery
Your radio comes with a rechargeable Li-Ion Polymer
battery; for shipping safety, the battery is not installed at
the factory. The empty alkaline battery tray is installed as
a placeholder.
1) Insert the tabs on the battery into the notches at the
top of the battery compartment.
#
Each time you remove the battery, check the rubber seal
around the battery compartment. Make sure the seal is
seated in the groove and there is no dirt or debris on it. If
the seal looks worn or damaged, contact customer service
to order a replacement (see back cover page for contact
information).
2) Lower the battery until it rests flat in the compartment.
3) Bring the battery latch up and snap it into place.
Using the Alkaline Battery Tray
The radio also comes with an alkaline battery tray that
holds four AAA-type alkaline batteries (not included).
You can use alkaline batteries as a backup for the Li-Ion
Polymer battery so you can still use your radio while your
Li-Ion Polymer battery is recharging.
