Uniden MHS550 Radio Owner’s Manual
20
Mounting the charger
You can mount the charger on any flat surface or on a wall.
Mounting on a flat surface
Use the three holes at the base of
the charger as a template to mark the
drill holes.
Using a ⅛ inch (or 3 mm) drill bit, drill
three holes ½ inch (13 mm) deep.
Use the provided screws to attach
the charger to the surface.
Mounting on a wall
Before wall-mounting the charger, be sure the wall material is
strong enough to hold the weight of both the radio and
charger. Use anchors appropriate for the wall material.
Using the holes in the rear of the charger as a
template, mark the location of the drill holes.
Using a ⅛ inch (or 3 mm) drill bit, drill two holes ½ inch
(13 mm) deep. (If you are using anchors, follow the
drilling instructions on the packaging.)
Insert the screws into the holes, leaving ⅛ inch (3 mm)
of space between the wall and the screw head.
Place the holes on the charger over the screw heads.
Slide the charger down to lock it into place.
1.
2.
3.
1.
2.
3.
4.
Use the charger
as a template to
mark drill holes.
1
Use the charger
as a template to
mark drill holes.
1
Place the charger
over the screw
heads and push it
down into place.
3
Place the charger
over the screw
heads and push it
down into place.
3
Insert the screws
(be sure to use a
proper anchor).
2
Insert the screws
(be sure to use a
proper anchor).
2
