26
Set up IP Addresses
1. From
System Setting/Network Parameter/Basic Setting
tab, check
Use Below IP Address
. The
IP
,
Mask
, and
Gateway
fields become active.
2. Enter a static IP address as assigned by the owner or the IT Department. If your system is not
in the same IP range as other computers on the LAN, you will not be able to remotely connect
to the system.
3. If given DNS1 and DNS2 settings, enter them in the section below the IP settings [required if
connecting to another device by name (not by IP address)], such as an FTP, SMTP, or NTP
server.
4. Click
Save
in the bottom right corner to save. Reboot is not required.
5.
Go to
Channel Setting/Channel Connecting
to add cameras (see Set up IP Cameras on this
page. Make sure each camera has a different IP address in the same range as the LAN.
6. Once each device has an individual IP address, open a web browser on a remote computer or
device and access the IP cameras or the recorder.
7. If a WiFi access point is connected to the LAN, connect the Uniden ProSeries Mobile app (or
via a web browser) to remotely access the recorder and cameras.
Adding Optional IP Cameras
All cameras are assigned to LAN1 IP range.
1.
Go to
Channel Setting/Channel Connecting
. Check
Modify the IP address when add channel
on the right side of the screen. Click
Add All
from the left side of the screen.
Modify the IP
address of IPC
displays if needed
2. Select
Forced to modify IP address
and click
Confirm
. System changes all of the cameras' IP
addresses and adds them to the system.
Prerequisites
• Static IP address in LAN1
• Make sure the IPC range is the same as LAN1 on the system.
• Power up the recorder and select
Channel Setting/Channel Connecting
.
1. Select search protocols and then click
Search
. Recorder scans the network for IPCs while a
countdown displays in the
Search
button. When done, a list of IPCs display below the
Search
button.
