5. Press and hold
/
BAND to start Limit search.
The VFO knob allows you to toggle through the
bands. Then press
/
BAND again to start band
search.
6. Press
to stop Band serch, Limit search and WX
scan. Also, press it to move to next higher channel or
frequency. Press and hold
to change the
search direction to upper side.
7. In Limit search, input the frequency and press
to program the lower/higher frequency. Press
to stop Band search, Limit search, and WX scan.
Also, press it to move to next lower channel or
frequency. Press and hold
to change the
search direction to lower side.
8. Press
/
ALERT to change the display mode when
you program frequency or Alpha characters. Press and
hold
/
ALERT to set the Alert Beep function in
Manual mode.
9. Use
/
CLR to enter the decimal point when
programming a frequency into a channel. If you
make an entry error, press
/
CLR before the
key to erase the entry, and start over. Also, use
/
CLR to clear the error message display.
10. Press
to store a displayed frequency and
CTCSS/CDCSS Data and Alpha characters into any
displayed channel.
11. Press
to “Lock Out” or prevent scanning of the
displayed channel, including Priority Channels. (L/O
appears on the display.) To unlock a channel, press
again.
can be used for Scan or SEARCH
Modes.
12. There are 10 Preprogrammed NOAA and Canada
weather channels. Press
/
ATT to find the active
NOAA and Canada weather channel in your area.
WX appears on the display in Weather Mode. If you
want to set or reset the Attenuator function, press and
hold
/
ATT.
13
