Se
tting up the
Phone
[ 1 1 ] S e t t i n g u p t h e P h o n e
w w w . u n i d e n . c o m
Connect the base unit and charge the handset
1) Connect the AC adapter to the
DC IN 9V
jack and
to a standard 120V AC wall outlet.
Connect the AC adapter to a continuous power
supply (i.e., an outlet that is not controlled by a
switch).
Place the base unit close to the AC outlet to
avoid long extension cords.
2) Place the handset in the base unit with the top
panel facing forward.
Connect the AC adapter to a continuous power
supply (i.e., an outlet that is not controlled by a switch).
Place the base unit close to the AC outlet to avoid long extension cords.
3) Make sure that the
charge
LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the base charging contacts.
4) Charge your handset at least
10 hours before plugging into the phone line
.
5) Once the handset battery pack is fully charged,
connect the telephone line cords to the
TEL
LINE
jack and to a telephone outlets.
•
Use only the supplied
AD-0009 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
•Don't place the base in
direct sunlight or
subject it to high
temperatures. The
battery may not charge
properly.
for assistance.
If your telephone
outlet isn't modular,
contact your
telephone company.
note
UP743.book Page 11 Monday, November 29, 2004 9:28 AM
