A D D I T I O N A L I N F O R M A T I O N [ 5 6 ]
w w w . u n i d e n . c o m
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register all the handsets you have (see "De-register the Handset" on page 30).
2. Register the handsets by following step 2-3 in "Registering the Handset" on
page 16.
Find Handset
To locate the handset, press
find handset
on the base when the phone is in
standby mode. All registered handsets beep for 60 seconds, and
P ag i ng
appears on
the handset display. To cancel paging, press any key on the handset or
find
handset
on the base.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from
the holes.
If the battery pack is
completely drained, the
handset will not beep
when paging.
note
ADDITIONAL
INFORMA
T
ION
