56
Resetting the Handset Without the Base
If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.lost.or.somehow.incapacitated),.you.can.still.
reset.the.handset.and.use.it.with.another.base.
Press.and.hold.
[
]
.and.
[#]
.for.at.least.5.seconds.
Move.the.cursor.to.select.BASEUNAVAILABLE.and.then.press.
[select/
]
..BASE.UNAVAILABLE.appears.
Move.the.cursor.to.select.YES,.and.then.press.
[select/
]
. You hear a confirmation tone, and the handset
deletes.its.own.base.information.without.contacting.the.base..The.handset.displays.HANDSET.NOT.
REGISTERED-PLACE.HANDSET.ON.BASE.TO.REGISTER..SEE.YOUR.OWNER'S.MANUAL.FOR.HELP...
Register.the.handset.to.the.new.base.(see.Registering.Accessory.Handsets.on.page.22).
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base. Your unit ships from the
manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.you.
suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.by.a.
manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:
Reset.all.of.your.handsets.(see.Resetting.the.Handset.on.page.55).
Re-register.each.handset.(see.Registering.Accessory.Handsets.on.page.22).
Traveling Out of Range
During.a.call,.if.you.move.your.handset.too.far.from.your.base,.noise.may.increase..If.you.pass.the.range.limit.of.the.
base,.the.handset.will.beep,.display.OUT.OF.RANGE,.and.then.go.to.standby..The.base.will.maintain.the.connection.
for.30.seconds.after.the.handset.goes.out.of.range..If.you.move.the.handset.back.within.range.of.the.base.within.30.
seconds,.press.
[
/flash]
.or.
[
]
.to.pick.up.the.call.again.
)
2)
3)
4)
)
2)