28
Operation
resumes scanning automatically after the delay time
(see Delay on Page 29).
Notes:
•
If you have not stored frequencies into any
channels, the scanner does not scan.
•
If the scanner picks up unwanted partial or very
weak transmissions, increase the squelch level.
Decrease the scanner's sensitivity to these
signals. To listen to a weak or distant station,
reduce the squelch level (0 is squelch open).
Manually Selecting a Channel
You can continuously monitor a single channel
without scanning. This is useful if you hear an
emergency broadcast on a channel and do not want
to miss any details - even though there might be
periods of silence - or if you want to monitor a
specific channel.
During scanning, if the radio stops at a channel you
want to listen to, press
RSM/HOLD
once.
(Repeatedly pressing
RSM/HOLD
at this time
causes the scanner to step through the channels.)
Press
RSM/HOLD
to resume automatic scanning.
Switching the Mode
Follow the steps below to switch between
Frequency Mode and Memory Mode.
1. Repeatedly press
F/M
to display
FREQ
.
Now the scanner is in Frequency Mode.
2. Repeatedly press
F/M
to display
MEM
.
Now the scanner is in Memory Mode.
UB333 Paper OM reduced size.fm Page 28 Friday, June 3, 2005 1:43 PM
