After the scanner finishes checking a trunked system
for activity, it will conventionally scan the other
frequencies in the bank (remember, only trunking
frequencies are programmed in Trunk mode).
To scan a mix of trunking and conventional banks, select the
banks you wish to be active, and then press
SCAN
. The
scanner will instantly begin scanning. If you have not
programmed a trunking bank with talkgroup ID’s, you will
receive
NO ID (----)
message for that bank.
You can switch to Search mode and the scanner will search
for any active ID’s on the system.
Note
: To switch ID Scan or ID Search, press and hold
TRUNK
in the trunked system.
Multi-Track Operational Details
When more than one trunk system is active (for example two
or more trunked systems or a trunked system and one or
more conventional frequencies), the radio jumps between
systems/frequencies as follows:
TRUNK SCAN
: The scanner moves to a trunked system
and looks for IDs in your Scan List(s) for up to 1 second.
If it finds no activity on your programmed talkgroups, it
moves on to conventional channels in the same bank or to
the next active bank.
If the scanner finds that a talkgroup in one of your active
Scan Lists, you will begin to hear that communication and
the scanner will of course display the proper talkgroup
number and any alpha tag. When the communication
ends, the scanner will wait for 2 seconds for any further
replies and, if none, the scanner will move to the
conventional channels in the same bank or to the next
bank. The scanner will not look for any other IDs within the
same trunked system (as this would slow the scan
process). If you press
RSM
while you are listening to one
ID, the scanner will check to see if another ID in your Scan
List is active. It will disregard the ID to which you were just
monitoring.
TRUNK SEARCH
: This mode works similarly to Trunk
Scan. If the scanner finds any (non-locked-out) ID when
it checks the control channel, you will hear it. You will then
hear any replies that follow within 2 seconds. After that the
scanner will move on and not continuously search the
system for additional IDs (on busy systems you would never
leave the system if this were the case). If you press the
RSM
key while monitoring one ID, the radio will check if any
other IDs are active (it will disregard the ID you just left),
and if none are active, it will move on.
59
UBC3300XLT OM 5/14/04 3:29 PM Page 59
Summary of Contents for UBC3300XLT
Page 1: ...UBC3300XLTSCANNER ...
Page 2: ......
Page 99: ...Memo 95 ...
Page 100: ...2004 UBZZ01315AZ ...
