13
Setting Up The Scanner
Setting Up The Scanner
These guidelines will help you install and use your new scanner:
If your scanner receives interference or electrical noise, move the scanner
•
or its antenna away from the source. You might also try changing the
height or angle of the antennas.
Use an optional mono earphone or mono headset with proper impedance
•
for private listening.
Do not use the scanner in high-moisture environments such as in the
•
kitchen or bathroom.
Avoid placing the scanner in direct sunlight or near heating elements or
•
vents.
Connecting Power
Insert the supplied AC Adapter’s
•
barrel plug into the power jack
on the back of the scanner. Then
plug the Adapter into a standard
household outlet that supplies
240V AC, 50Hz. Do not plug the
adapter into a switch controlled
outlet.
Open the battery compartment
•
and insert 3 AA batteries.
Be sure to note the polarity markings in the
battery compartment. You can use either
alkaline or rechargeable batteries, but the
scanner will not recharge batteries in the
compartment.
• Use only fresh alkaline AA batteries.
Rechargeable batteries can be used, but
battery life is shorter than with alkaline
batteries.
• Always remove old or weak batteries.
Batteries can leak chemicals that destroy
electronic circuits.
• Do not mix old and new batteries,
different types of batteries (standard,
alkaline, or rechargeable) or rechargeable batteries of different
capacities.
240
Model AAD-008S
UBC330CRS OM.indd 13
10/9/09 12:42:16 PM
