Using the Scanner Memories
Once you fill out the above chart, follow these steps to enter or change a
frequency in a memory:
. Press
E/PGM
to enter the program mode (the scanner turns on the
PGM icon).
. If the current channel is not the one you want to program, enter the
memory number then press
HOLD
.
. Enter the frequency including the decimal point, then press
E/PGM
.
4. To program the next memory, press
s
or
t
and repeat step . To
program a different memory, repeat from step .
5. To exit program mode, press
HOLD
or
SCAN
or change the scanner’s
mode.
Notes:
• Any frequency you program replaces the previous memory contents.
• If you enter a frequency you have already stored in a different
memory in Step , the scanner beeps and displays the channel
where you have previously stored the frequency. If you want to store
the frequency anyway, press
E/PGM
a second time in Step .
• To clear the contents of a memory, enter “0” in Step .
• Channels you program are automatically unlocked (see “Locking/
Unlocking Memories) and have Delay turned on (See “Setting
Channel Delay”).
Selecting a Memory
To select a single memory to monitor, press
HOLD
. The scanner turns
Bank 6
Bank 7
Bank 8
Bank 9
Bank 10
5
6
7
8
9
5
6
7
8
9
5
6
7
8
9
54
64
74
84
94
55
65
75
85
95
56
66
76
86
96
57
67
77
87
97
58
68
78
88
98
59
69
79
89
99
60
70
80
90
00
UBC40CRS OM.indd
7/5/08 4:8:9 PM
