21
1.
Make sure the power is turned off .
2.
Slide the battery compartment cover off .
3.
Use a pointed object such as a ballpoint pen to set the
battery selection switch inside the compartment to
Ni-MH
.
4.
Install two batteries in the compartment as indicated by
the polarity symbols (+ and -) marked inside the battery
compartment.
5.
Replace the battery compartment cover.
Note:
To prevent damage to Ni-MH batteries, never charge
them in an area where the temperature is above 45°C or below
4°C.
Charging the Ni-MH Batteries through USB Connection
The scanner has a built-in circuit to charge the Ni-MH
batteries when a USB cable connects it to a computer (NOT
to a USB hub) or to an AC or DC adapter that provides USB
charging power. Verify that the battery selection switch is
set to
Ni-MH
and that only Ni-MH rechargeable batteries are
inserted in the scanner before connecting it to your power
source.
CAUTION: Never attempt to charge non-rechargeable
batteries or install non-rechargeable batteries when
the battery selection switch is set to Ni-MH.
1.
Be sure the scanner is turned off . It will recharge only if
it is turned off , even with the USB cable connecting it to
a computer.
2.
Connect the included USB cable to the scanner’s USB
port.
UBC75XLT̲UB372BV̲20130401.indd 21
UBC75XLT̲UB372BV̲20130401.indd 21
2013/04/02 11:08:34
2013/04/02 11:08:34
