23
If the batteries are good, the scanner charges the batteries.
and it operates normally. If the scanner cannot immediately
determine if the batteries are good and can be charged, it
checks them and displays the battery icon. If the scanner
judges the batteries are good, the scanner starts charging
and the battery icon disappears. If it cannot regard the
batteries as good in 60 seconds, the scanner stops checking
and the battery icon blinks.
Low Battery Alert
The Low Battery Alert tone sounds every 15 seconds and
the battery icon fl ashes when the battery voltage is low. If it
drops below the threshold, the scanner automatically shuts
off until the battery is recharged.
TURN ON THE SCANNER
Turn on the scanner after it has been completely charged
(Ni-MH batteries) or alkaline batteries have been installed.
Note:
Make sure the antenna is connected before you turn on
the scanner.
1.
You can select the band plan (Band Plan 1 or 2) when
you turn on the scanner (default = Band Plan 1). Press
and hold the
key for 2-3 seconds to turn on the
scanner and then press and hold
1
for Band Plan 1 or
2
for Band Plan 2. The band plan will remain until you
change it again.
2.
If this is the fi rst time you have turned on the scanner,
All LocOut
displays. This means that no frequencies
have been saved into channels. Press
Srch
to begin
searching.
UBC75XLT̲UB372BV̲20130401.indd 23
UBC75XLT̲UB372BV̲20130401.indd 23
2013/04/02 11:08:34
2013/04/02 11:08:34
