16
10:EDACS ID FORM
(EDCS)
You can change to display the talkgroups in decimal mode, but this mode does not
provide you with nearly the flexibility that you get with AFS. The UBC780XLT
defaults to show the talkgroup number in AFS mode (Agency-Fleet-Subfleet). For
details on AFS see pages 46.
11:END CODE
(MOTOROLA)
When this function is disabled, the radio looks for squelch before returning to the
control channel instead of waiting for the disconnect tone. Only in rare instances
will you need to adjust the default settings.
The condition to return to control channels depends on whether signal is present or not.
12:CONTROL CH ONLY
(MOTOROLA 800 & 900 SYSTEMS)
With this mode you will be able to track Motorola Type I and II 800 and 900 MHz
trunked systems by simply entering the control channel which manages the trunked
system. You will not have to program the voice channels. There are 4 channel
plans which you can select from.
4:SEARCH EVENT
You can program up to 10 search ranges (one per bank). The first time you
program a range for a bank you will need to do so through the Menu. After the first
time you can program a range as you do on most any other scanner, using the
numeric keypad and the
▲
/HOLD or
▼
/LIMIT keys.
1:SEARCH BANK
Use this Menu item to select the search bank that you want to program. You can
program banks 1 through 10, one at a time. For each of the banks, the following
options can be modified.
1:EDIT RANGE
Enter the upper and lower frequency limits of the search range.
2:STEPS
You can assign a variety of step sizes to the search range. Note: The
default step is usually acceptable and is listed in the front of the manual.
(See inside front cover)
3:MODE
You can change the default receive mode with this menu item.
4:ALPHA TAG
You can alpha tag any or all of the search banks.
2:DELAY
Set a delay for the search ranges. This applies to all ranges (See CHANNEL DATA-
STEPS for details).
3:ATTENUATOR
Set attenuation for all search ranges. (See CHANNEL DATA-ATTENUATOR
for details).
4:TONE DATA
The default mode is off. This means that you will receive all transmissions on any
frequencies that are active within your search range(s). By selecting CTCSS or
DCS you can set the radio to receive only a particular subaudible tone to be
Summary of Contents for UBC780XLT
