40
ID Scan Mode
1. Press
SCAN
to begin scanning the lists you
have programmed.
If you haven't programmed any IDs,
ERROR
appears
for a few seconds.
2. To remove a Scan List from active scanning, press
the number of the Scan List on your keypad.
The Scan List indicator turns off, and the IDs in that
list are not scanned.
Note: One Scan List must always be active. If you try
and deactivate all the Scan Lists, Scan List 1 will
automatically be active.
3. To restore a Scan List to active scanning, press its
number again.
4. Press
SRCH
to return to Trunk Tracking Search mode.
For motorola and EDACS system, to change your
display between the Scan List indicators and trunk
bank display, press
SELECT
.
For LTR systems only, the talkgroup must be active in
order to change the scan list and bank indicators. If
the talkgroup is not active, change the scan list by
using the menu screen.
Note: • Once you press
SCAN
or
SRCH
in one bank, all trunking banks will change to
that mode.
• Selecting a Scan List is also possible in the menu mode. (LTR only)
•
ID SCANNING
appears on the bottom of the screen during Trunk Scan instead of
simply
SCANNING
.
Summary of Contents for UBC780XLT
