UBCD396XT
28
11. EDACS Trunked Systems
Please note that these pages are meant as general instructions.
This section deals with EDACS Wide or standard systems. This includes EDACS
systems that use ESK.
No special setting is needed to enable
ESK tracking on an EDACS system. Note
that the scanner cannot decode EDACS ProVoice.
Programming an EDACS System
To program an EDACS system, you'll need to program the required elements in
following order:
Create a system
1.
Go to the
Program System
menu and choose
New System
.
2.
The scanner will prompt you for the System Type. Select
EDCS
.
3.
The scanner will prompt you for the sub-type. Select
Wide/Narrow
.
4.
When the scanner prompts you confirm, tap
YES
.
5.
The scanner creates the system with a default name. Select
Edit Name
if you
want to change it.
6.
If you need to change any of the system properties, you can do that now.
Unless a property is
Required
, you can operate the system without changing
the default settings.
System properties
All of these options can be found under your scanner's
Program System
menu. If
necessary, the submenu and option name on each scanner are listed beside the
property.
Property Option
name
Required
None
Recommended
Name
Edit Name
Number tag
Set Number Tag
Optional
Summary of Contents for UBCD396XT
