UBCD396XT
36
12. LTR Trunked Systems
Please note that these pages are meant as general instructions.
Programming an LTR System
To program an LTR system, you'll need to program the required elements in
following order:
Create a system
1.
Go to the
Program System
menu and choose
New System
.
2.
The scanner will prompt you for the System Type. Select
LT
.
3.
When the scanner prompts you confirm, tap
YES
.
4.
The scanner creates the system with a default name. Select
Edit Name
if you
want to change it.
5.
If you need to change any of the system properties, you can do that now.
Unless a property is
Required
, you can operate the system without changing
the default settings.
System properties
All of these options can be found under your scanner's
Program System
menu. If
necessary, the submenu and option name on each scanner are listed beside the
property.
Property Option
name
Required
None
Recommended
Name
Edit Name
Number tag
Set Number Tag
Optional
Automatic Gain Control
(AGC)
Set Audio
AGC
Delay time
Set Delay Time
ID scan/search
ID Scan/Search
Priority ID scan
Priority ID Scan
Summary of Contents for UBCD396XT
