UBCD396XT
81
Entering the Quick Key toggles the enabled/disabled state of the
system/site/search range or channel group (i.e., if the system is currently
enabled, entering the Quick Key will disable it, and vice-versa).
To use SQK 0 through 9
Enter Scan mode.
Tap the number key that matches the SQK. (For example, if the SQK is
4
,
just enter
4
.)
Any systems, sites, or search ranges assigned to this SQK become disabled.
(If they were already disabled, they become enabled.)
To use SQK 10 through 99
Enter Scan mode.
Tap the decimal point (
./NO
), then enter the SQK. (For example, if the
SQK is
32
, enter
./NO
/
32
.)
Any systems, sites, or search ranges assigned to this SQK become disabled.
(If they were already disabled, they become enabled.)
To use a GQK
Enter Scan mode.
Go to the system that contains the channel group you want to enable or
disable.
Tap
FUNCTION
, then tap the number key that matches the GQK. (For
example, if the GQK is
7
, enter
FUNCTION
/
7
.)
Any channel groups assigned to this GQK
within the current system only
become disabled. (If they were already disabled, they become enabled.)
Summary of Contents for UBCD396XT
