Operation - Special Features
39
UNIDEN UH9050
UHF CB Transceiver
100 User Programmable RX Channels
The UH9050 has 100 receive only channels (CH81 to CH180) which can be
programmed with frequencies ranging from 400-520MHz (in 12.5kHz steps). The extra
RX channels only appear, as part of the CB channel bank, when a frequency has been
programmed to a channel. There are two ways to programme RX channels;
1. If you know the frequency you may manually programme it to a channel.
2. Store a Police or Fire (& Ambulance) frequency to a channel.
Furthermore, the RX channels can be Alpha Tagged (given a name) if desired.
Manually Programme a RX Channel
In CB channel mode (UHF CB channel);
1. Press & hold
[MENU]
. The lowest available empty RX channel will flash.
2. Turn the Rotary
PWR/VOL
if you wish to select another RX channel from CH81 -
CH180.
3. Press the Rotary
PWR/VOL
to confirm selection and begin the frequency edit. The
MHz digit range flashes. Use or to shift between MHz range (between 400-
520MHz) & kHz range (in 12.5kHz steps).
Turn the Rotary
PWR/VOL
to select the desired frequency within MHz & kHz ranges.
4. When desired frequency is entered press the Rotary
PWR/VOL
to move to Alpha
Tag selection. A cursor flashes in the 1st alpha position.
If you do not wish to name the channel then skip this step.
Turn the Rotary
PWR/VOL
to select the desired alpha character.
Use or to shift between cursor positions.
5. When finished press the Rotary
PWR/VOL
. A long confirmation tone sounds to
indicate the new channel is programmed. The channel flashes to enable
selection for programming of next channel if desired.
6. Press and hold
[MENU]
to save the setting and exit programming mode.
