U S I N G Y O U R P H O N E [ 3 6 ]
w w w . u n i d e n . c o m
USING Y
OUR
P
H
ONE
Storing a Redial Record (Handset only)
1) With the phone in standby mode, press
redial/p/vol/
.
2) Press
cid/vol/
or
redial/p/vol/
repeatedly to display the number to be
stored.
3) Press the
EDIT
soft key, then select
S to r e in t o P B?
, and then
OK
soft key.
4) To complete the setting, follow the steps 3-8 in "Entering New Phonebook
Entries and Speed Dial Numbers" on page 44-45.
Adjusting the Earpiece and Speaker Volume
You can select from among six volume levels on the
handset and ten levels on the base. Pressing the
volume up
key or
volume down
key during a call will
change the earpiece or speaker volume. This setting
will remain in effect after the telephone call has ended.
If you press the volume up key when the earpiece is at
the maximum volume level, an error tone sounds.
The error tone also sounds if you press the volume
down key at the lowest volume.
Muting the Ringer
Ringer off (ring off)
The ringer off feature allows you to mute the ringer, the base, and any registered
handsets at the same time. The phone must be in standby mode. Press and hold
ring
off
on the base. You will hear a confirmation tone, and the ring off LED illuminates.
To cancel the ring off feature, press
ring off
again. You can also mute the ringer
tone while the phone is ringing by pressing
ring off
on the base.
•While charging a
handset, you can not
mute the ringer tone
for the handset.
•Any phones connected
to the PHONE port on
the back of the
UIP165P will still ring
even when ringer is
turned off.
note
Summary of Contents for UIP165P
Page 1: ...UIP165P OWNER S MANUAL...
Page 73: ...7 2 w w w u n i d e n c o m Memo...
