background image

STANDARD FEATURES

l

RF Remote Control — Comes with
slim-line transmitter.

l

RF Panic Alert — Pressing
transmitter button #1 for 3 seconds
will sound the siren.

l

Quiet Mode — Pressing transmitter
button #2 followed by button #1 will arm or disarm the alarm without chirping.

l

Audio Confirmation — Siren chirps once when armed, twice when disarmed, and
three times for zone override (such as a door is open when armed).

l

Multi-use Remote Control — Transmitter button #2 can also be used to open or
close a garage door when used with the optional SEA910 receiver or control another
Uniden VS1100XR or VS2100XR.

l

Alarm Status LED — The LED will indicate whether the alarm is armed (LED
flashes) or disarmed (LED is off), also which sensor was triggered.

l

Unique Built-In Electromagnetic Shock Sensor (with pre-intrusion feature)
Revolutionary sensitivity-stable design ensures the sensor never needs readjusting
once it is installed.  Constructed to eliminate contact problems associated with
corrosion, cold-soldering, and condensation.  If there is a light shock to any part of
the vehicle, the siren will "chirp," but the alarm will not trigger.  If a harder impact is
made to the vehicle, it will trigger the alarm and sound the siren.

l

Complete Protection for the Car — The alarm triggers when:

1. A drop in current from the car's battery is sensed (e.g. when domelight comes

on).

2. Shock or impact to the car is sensed.

3. Any attempt is made to start the car engine when the alarm is armed (starter

sensing).

4. Any door of the car is opened.

l

115dB Siren — Will blast for 25 seconds upon intrusion and will reset automatically.

l

Car's Door Lock/Unlock — Locks or unlocks the doors when the alarm is armed or
disarmed. (VS255XR only) Optional accessories may be required.

l

Parking Lights and Car Locator — One flash for arming, two flashes for disarming,
3 flashes for tamper zone overridden and 4 flashes for tamper indicator. (VS255XR
only)

l

Door Switch Input — Normally-open (N.O.) negative trigger input.

l

Backup Battery Capability — Use a rechargeable 9V Nickel-Cadmium battery (not
included) to provide backup power to the alarm.

®

VS235XR / VS255XR

Self-Contained,  RF Remote-Controlled Vehicle Security System

Rechargeable backup battery capability
3-channel transmitter
With rolling code & code learning technology

CBA

VS235XR / VS255XR

COMPARISON

Flashing Light Relay Output

Door Lock/Unlock Output

Alarm Status LED

Negative Door Input

Number of Wires

VS235XR

l
l

6

VS255XR

l
l
l
l

9

Summary of Contents for VS235XR









Reviews: