[ 24 ]
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset too far from your base unit, noise
may increase. If you pass the range limits of the base unit, you will hear a beep and
see
Out of Range
on the display, and then the handset returns to standby mode.
You may return to the call if you move your handset within the range limits of the
base and press
or
speaker
within 30 seconds.
MUTE MICROPHONE
You can temporarily turn off the microphone so that the person you are talking with
cannot hear you.
1) Press
/del
during talk mode (while phone is in use).
2) Press
/vol/
or
/vol/
to move the pointer to
Mute
and then
.
Mute On
and
appear in the display. To cancel muting, repeat above step again
when Mute is set to on,
Mute Off
appears.
TONE DIALING SWITCH-OVER (AUSTRALIA ONLY)
Some telephone companies use equipment that requires pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. This feature is useful when you need
tone dialing to use automated systems, for example, entering
your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once
your call connects, press
. Enter the desired
number. These digits will be sent as tone dialing. Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number
can be stored in a
memory location.
This is referred to as
Chain Dialing (see
page 35)
UP349BH (WDECT2300) ENG OM 1/5/05 1:18 PM Page 24
