4
INSTALLING YOUR HANDSET
Charge the Battery
1. Remove the cardboard spacer.
2. Press the power on/off (activation) pin according to the directions on
the label.
3. Remove the label once the handset is powered on.
Save the power on/off pin in case you need to change the
handset’s power status later (i.e., to power off the handset when
it will not be used for a long time). Use the plastic power on/off
pin or a blunt-tipped object like an uncurled paper clip to press
the power on/off toggle through the rubber seal. Do not use a
sharp object; sharp objects might puncture the rubber seal and
jeopardize the handset’s waterproof status.
4. Connect the AC adaptor to the charger’s
DC IN 9V
jack and set the
cord into the notch. (This adaptor might already be connected.)
5. Plug the other end of the adaptor into a standard 240V AC power
outlet.
6. Place the handset in the charger with the display facing forward. The
display on the handset should turn on.
The handset’s rechargeable battery is already installed. Before you can
charge the battery, you have to power it on.
If..
Try..
the handset display does not
turn on
•
Checking the AC adaptor
connection.
•
Seeing if the outlet is controlled
by a wall switch.
#
Charge the Handset completely (16 hours) before using it.
