Close Control Regulation Program
32 06MC0071@00B0110
01/10/2012
ALARM RELAY SELECTION
This screen is used to change the status of the alarm signal contact,
type “A” and “B”.
This screen and the following are used to determine the digital output
that signals the alarm. The configuration of an alarm does not affect
the action performed by the controller (signal only on the display or
shutdown of the device affected by the alarm).
STAND-BY ROTAT. ALARMS
This screen and the following are only displayed if the local network is
configured, and are used to manage the start-up of the stand-by unit if
an alarm is activated.
Putting the value to YES, activates the rotation.