UNIFLEX-Hydraulik – 11 – www.uniflex.de
Chapter 4
Commissioning
Note:
The machine may only be commissioned and operated by trained and authorized personnel!
Unpacking / Set up
The cutting and skiving machine was tested prior to delivery and is ready for operation.
How to prevent damage when unpacking:
•
Carefully remove all packaging.
•
Check the delivery for completeness using the delivery note.
•
Remove all screws that fasten the machine to the packaging.
•
Use suitable lifting gear to lift the machine off the palette.
Note:
Pay attention to the correct balance!
Note:
Set the machine in such a way that it is accessible from all sides for maintenance works.
Note:
Only set up and operate the machine in weather proof rooms.
•
Lift the machine on the included workbench (optional).
•
Fasten the machine to the workbench. (Rubber-metal buffer reduce vibrations).
Note:
The work bench must be level.
The cutting support should go further than the desk so the hose can be guided towards the cutting knife or the
round brush freely (EM 3.4 DC; EM 3.2 Ecoline).
Summary of Contents for EM 1
