UNIFLEX-Hydraulik – 17 – www.uniflex.de
Brushing
•
Prepare the machine as detailed above.
•
Insert the skiving mandrel in clamping device A and secure with clamping decive B.
•
The skiving length is set by the positioning of the skiving mandrel (+ or –).
•
Place the hose end on the skiving mandrel and hold while you use setting screw E to move the hose against
the round brush. Do this until the desired skiving depth has been reached.
•
Fasten the clamping screw F. Then start the motor using the main switch (Position «I»).
•
Use both hands to turn the hose over the skiving mandrel. When the skiving process is finished, carefully
remove the hose.
•
Turn the machine off by operating the OFF-Switch «O».
EM 2
A
E
F
B
Summary of Contents for EM 1
